STREET LIGHTING ENERGY SAVER
Lighting plants are connected to mains that are subject to voltage variations caused by both the distribution source and seasonal and daily load variations. Lamps, to operate correctly should be fed with a voltage that does not exceed 5% of nominal voltage.
Very often while the plant is operating, much higher value occur, voltage fluctuation and especially over-voltages, are extremely critical for all lighting sources, limiting the use.
Therefore, to have the best performance Stabilizing is necessary, and this must be carried out with very reliable technologies having high recovery rate on the mains variation.
Therefore, to have the best performance Stabilizing is necessary, and this must be carried out with very reliable technologies having high recovery rate on the mains variation.
The Cd flux regulator for lighting plants is fruit of the automatic voltage stabilizer technology. When installed in a new or preexisting plants it enables line voltage stabilizing and also Regulation within the nominal value and a minimum Value compatible with the type of lamp used.
The purposed of this is to reduce the power absorbed, thus cutting down the consumption by up to 50%. Besides increasing the life of the lamps install also drastically cuts maintenance and replacement costs.
STATIC POWER LINE CONDITIONER (PLC)
• Static switch tap changing technology
• Very fast correction time
• No mechanically moving part
• Single / Three phase supply
• 1kVA to 1000kVA.RFI filter
• Lightning / Surge protector
TRUE ONLINE UPS
• Pure sinewave output
• Microprocessor controlled
• Single / Three phase system
• 1kVA to 150kVA
LINE INTERACTIVE UPS
• Simulated sinewave output
• 600VA to 5000VA
• Built-in Automatic Voltage Regulator (AVR)
• Modem / LAN port protection
EXTENDED BACK-UP UPS (Specially Designed & Built For Extended Hours Back-Up Operation)
• Built-in AVR
• Lightning & Surge Protection
• Heavy Duty Inverter For Extended Hours Back-up
• Line-Interactive Technology
• Heavy Duty Charger For Shorter Battery Recharge Time
AC STAND-BY POWER SUPPLY
• Generates electrical power from stand-by battery in the event of mains
failure
• For lighting, fan, water pumps and other electrical appliances
• Operates on car batteries or maintenance free SLA batteries
• 100W to 5000W output
28VDC AIR-CRAFT STARTER
• Ground power unit (GPU) for hangar
• DC 28V up to 2000A from 415V AC source
SOLAR POWER SYSTEM
• Solar panels
• Solar charger
• Solar batteries
• DC to AC inverter
• Hybrid system incorporated auto start gen-set
AMF BOARD
• Control board to automatically start stand-by gen-set and change-over of
electric power from mains to gen-set and vice versa
• 12V or 24 V battery starter system